Joint design made to measure

In order to place something behind the panel joints, the supporting profiles are equipped with joint profiles. The aluminium joint profiles can be anodised and lacquered. You can make your own joint profiles in matching decor using 4mm board material. Perforated joint profiles can be fitted when using supporting brackets. They must also be equipped with joint profile securing clips and secured in the supporting profile.

The joint profiles can only be clipped in during assembly and after they have been finely adjusted.
The horizontal joint profile, which is also made of aluminium, is also available for horizontal joints up to 30mm. It is fixed to the panel using Keku^® AS fittings. Perforated joint profiles are fitted when using brackets. They must also be fitted with joint profile securing clips and secured in the supporting profile. The securing clips should be placed near the brackets.

The following applies for the Keku^® room system:
The wide range of accessories enables practical detailed solutions.